Description

6.2.1.10  - 20240125

• Implement secure discovery protocol that allows for IP identification and resetting of the unit.  Useful to identify a forgotten IP address.
• Include advanced routing configuration in wancheck. During a service restart any existing advanced routing routines would be removed.
• Disconnect RX/TX RF circuits before rebooting when in LTE mode. Previously powering down the module could cause a panic on the communication interface.
• Fix a bug where the subnet was not been set correctly on the WAN interface.
• Show chipset sub version when in LTE mode.
• Improve removal of stale nodes/edges from active connection list.
• Prefered MTU size occurs more often which improves packet size discovery.
• WAN check now deals with interfaces that don't become active after a period of time. Before the service would wait until activity occured before progressing. It now assumes something has gone wrong and forces a reboot.
• During a reboot, first disconnect from any active session. This should reset any PDU to CPE network session.
• Improve storing and loading of platform identity to be used for validation when upgrading.
• Display Connection Type within signal strength indicator.

6.2.1.08c - 20231004

1.) Implement Network Dual Stack with IPV4 preferrence [AT$QCPRFMOD=PID:1,OVRRIDEHOPDP:"IPV4V6"]
2.) Add a time delay response for RS485 signal handles. Fixes an issue where we were switching duplex too early.
3.) Added WAN checker. It will try to re-establish and existing session else reboot the unit after (failovertimeout * 10) seconds.
4.) Enable Web GUI on the WAN port

Extract the zip and upgrade using the file inside the zip, do not try to upgrade using the zip file